Attributes

Productgroup ID	2
Workpiece pallet total weight [mG]	30kg
ESD	yes
Pneumatic straight connection [Ø]	6mm
required compressed air connection [pmax]	6bar
required compressed air connection [pmin]	4bar
Weight	0kg
Notice	Pneumatic equipment PN = 2: Upper and middle lift position,Pneumatic equipment PN = 3: Upper, middle and lower lift position
Scope of delivery	Incl. fastening material,Pneumatic equipment for two or three positions,Assembly kit for electrical position inquiry,Protective housing
Delivery information	Fully assembled,Kit for electrical position inquiry included
Recommended accessories	Damper DA 2/60 for the outfeeding of workpiece pallets at v<sub>N</sub> > 9 m/min,Rocker WI 2/…, WI/M and dampers DA 2/60, DA 2/100-C for BG 2 for the infeeding of workpiece pallets
Required accessories	1x M12x1 sensor with rated sensing range S for each position inquiry<sub>N</sub> = 4 mm
Preferred values	160,240,320,400,480

• Lift transverse unit for feeding out of a from longitudinal section into a transverse section and vice versa
• Use in tight spaces by means of suspended drive motor (outside dimensions must be no wider than the section)
• Drive by toothed belt coupling is not possible because of the compact design
• Conveyor medium: Toothed belt (suitable for use in an EPA)
• Pneumatic equipment for 2 (top, center) or 3 (top, center, bottom) lift positions
• Suitable for mounting on an ST 2/… section with a profile width of 45 mm or an ST 2/…-H section with a profile width of 50 mm
• n.a.
• Reversible operation possible
• - n.a.

Lift Transverse Unit HQ 2/U
Pneumatic equipment for 2 (top, center) or 3 (top, center, bottom) lift positions, Conveyor medium: Toothed belt (suitable for use in an EPA), Reversible operation possible, Suitable for mounting on an ST 2/… section with a profile width of 45 mm or an ST

• 3D CAD
• Data Sheet

Recommended accessories

Damper DA 2/60 for the outfeeding of workpiece pallets at vN > 9 m/min

Rocker WI 2/…, WI/M and dampers DA 2/60, DA 2/100-C for BG 2 for the infeeding of workpiece pallets

M12 sensor with M12x1 push-in fitting

M12 sensor with M12x1 push-in fitting

CAD data

M12 sensor with M8x1 push-in fitting

M12 sensor with M8x1 push-in fitting

CAD data

Lift Transverse Unit HQ 2/U

L Transport direction of longitudinal section

Q Transport direction of transverse section

1 Stroke

2 Housing element

** With b onlyL = 160 mm

1) Profile height

Energy efficiency – Rexroth 4EE

Circuit diagram for unit with pneumatic equipment for two positions PN = 2

1)	Not included in the scope of delivery

Circuit diagram for unit with pneumatic equipment for three positions PN = 3

1)	Not included in the scope of delivery

No.			3842999903
Max. total weight of workpiece pallet	mG	kg	30
ESD			yes
Reversible operation			Reversible operation possible
Required compressed air connection	p	bar	4 ... 6 bar
Pneumatic push-in fitting	Ø	mm	6

Compressed air consumption of TS 2plus units

Motor connection

Transport and nominal speed vN

Motor data